hey fellow four wheelers.

I'd like to share my setup with the class!! please keep in mind that I have not raced this truck yet, but had a few track sessions to get this far.

shocks: 45 front, 35 rear, stock pistons.
diffs: 10k front, 3 k rear
clicker locked.
castle sidewinder sct and 1410, 3800 Kv geared with stock 48p spur and 18t pinion. motor temps at 160 after 20 minutes or more. (castle cust support has confirmed this is good temps for 5700 2 pole. can someone advise for the four pole?) esc temps at 100-105.
subcultures
four ballstud washers on front
3-4 deg negative camber on rear.
slight toe out on front.
track is prepared packed clay, near blue groove in some areas. short and tight.
ride height 1 inch front, < 1 inch rear.

results: as I stated, I don't have any race time. just practice time. the truck was traction rolling pretty bad until i got to 4 ballstud washers. it feels fast and handles like it is on rails. Once my schedule clears a bit, I'll race it and advise.

Where would i go about getting music wire to fab some swaybars?

I have forgotten that I have a t4.... for the time being.

Ben