No , about 120 on motor, and 100 on rx8, just tested on street, but ran it for about 12 MIN, running hard, I am thinking I have a motor problem, the motor had a 14mm rotor in it, and I put the stock one back in today, 14mm just too low KV for the 5.5, I did the rotor exchange to SOP, is it possible I could have damaged the motor changing it out??? I'm sure it's possible, but LIKELY??? I put card stock in the radius, and did it carefully, made sure the shims were good, little slop on the rotor, turned freely, ERRRRRRRRRR