R/C Tech Forums - View Single Post - 3racing F109
Thread: 3racing F109
View Single Post
Old 06-07-2011, 01:46 PM
  #1557  
kikcaffine
Tech Elite
iTrader: (32)
 
Join Date: Feb 2007
Location: Kennesaw, GA
Posts: 2,454
Trader Rating: 32 (97%+)
Default

Originally Posted by terry.sc
Those are just the plastic parts, you will also need the various ball joints and longer kingpins as well. The kingpin pivot balls should be the same as the F109 ones as 3Racing copied the design from Tamiya parts so you might be able to use the F109 ones. You might also want the F104 D parts for the servo mounts as they have a cut-out to clear the F104 rear mounting point, although you could just cut a section out of the servo mounts you have with the F109.

Parts you will need are
1 packs of 51381 F104 F parts
1 pack of 19808240 3x35mm bolts
1 pack of 19804206 5mm ball connector nuts
1 pack of 19808245 aluminium balls
1 pack of 19808246 aluminium balls
1 pack of 19808241 3x33 shaft

You can use the F109 steering knuckles, springs and centre mounting bolts rather than buy the F104 parts, they are identical so you don't need to buy them. You might want to add a couple of self tappers and washers to go on top of the steering stops, although they aren't necessary.

The manual for the F104 is here
http://www.tamiya.com/japan/download...al/f104pro.pdf
so you can see what parts are needed and how it is assembled.

With the front modified you will want to fit F104 wheels all round.
Glorious!

Thank you so much!
kikcaffine is offline