Originally posted by PMR
I'm inetrested with the topic you post in serpent's website regarding the modified flyweights. My question is, when you cut the shoe into three pieces what do you use? Dremel? Cutter?
Hi PMR,
My apologies for the long time in replying.
I have not been on the forum for a few days.
I personally don't use that method for modified flyweights, but others have done it with success. I use the original flyweights (on the pins) and add a small weight to the far end. I don't use the 3 separate flyweights cut from the single clutch shoe.
Regards,