Well for carpet foam would be the best choice but if you have to run rubber start with A at the rear,B at the front,really soft setup for the rear,zero camber and hard front springs.
You can sauce the tires if allowed.
Rear complete and for starters none front.
If this goes well keep to it.
If you still have to much bite at the front,try CA glue to the side walls at the front.
Good luck.
regards Roy
Originally Posted by
mattwoodcraft
i have not had a lot experience with foam tire's on the carpet i got a set of tamiya set a and b will be running on carpet for the first time with it, i got the 1.3mm t-bar in it the f1 at the moment should i just go out with the asphalt set up? or if so what changes might need doing, not a lot time for any practice just turn and race the event
thanks