Originally Posted by
evolution1
Hello,
In Genius Tool GII V. 1.6.5 for ESC GM120
"The Powercurves are only in function if Timing with Sensors is set to +30°"
Is this thrue ? The most drivers I know donīt set it on +30°. Powercurve is set on 9 (10.5motor). Whatīs the difference between timing is set on +0° or +30° ?
Someone good setup for 10.5 on asphalt outdoors ?
Tia, evolution
If you're using the v13 firmware with High Speed Timing enabled, the power curve setting doesn't do anything. As in my above post, read Martins guide and ignore everything else as it either doesn't do anything, or has already been set to the best starting values by Martin.
For 10.5 on a medium sized track (40m straight) I run:
15k switchpoint
80A current limit
18 Fixed Timing and 6.7 FDR with LRP x12
22 Fixed Timing and 6.7 FDR with Speedpassion v3
I use the Variable Dependence Timing as it keeps the motor cooler and allows higher timing settings.