R/C Tech Forums - View Single Post - 1/12 forum
Thread: 1/12 forum
View Single Post
Old 06-04-2011 | 07:47 AM
  #35969  
thedude007
Tech Initiate
iTrader: (17)
 
Joined: Jan 2007
Posts: 29
Default
Originally Posted by InspGadgt
1/8th are too big for the new CRC spurs...they do indeed use a 3/32nd ball. These do not snap in like the Kimbro gears and will slide through. Also you need to make sure you use an unflanged bearing in the middle.
Just to be clear, you're talking about bearing #2 in the attached pic.
This is for a 12R5.1 axle, would either of these work?
http://www.amainhobbies.com/product_...x3mm-Bearing-2

http://www.amainhobbies.com/product_...m-Ball-Bearing

The Associated bearing is .250"x.375"x.125"..so about 6.35mm x 9.5 mm x 3.175mm. The spur i'm using is: http://www.amainhobbies.com/product_...-Spur-Gear-72T

Thanks for helping the noob!!
Attached Thumbnails Click image for larger version Name: 12r5 axle.jpg Views: 272 Size: 73.7 KB ID: 762296  
thedude007 is offline  
Reply