Originally posted by racenut123
I just received my P-dub chassis and top deck(3mm) and was wondering if the guys running it are putting 1mm spacers to bring the roll centers{front and rear} back to stock.The stock chassis and riser plate are 4mm total.So the chassis and a 1mm spacer should get me back to where I started.
Can't answer your question, but just to correct a misunderstanding that seems to be common - using 1 mm thicker chassis with 1 mm thinner risers does not result in stock roll centre, because the upper inner pivot points will be 1mm higher than stock. The only way to get stock roll centres is to run stock risers (and to be totally correct, 1mm lower ride height). Or make new shock towers with 1 mm lowered upper arm pivot points.