R/C Tech Forums - View Single Post - Team Associated TC6 Thread
Thread: Team Associated TC6 Thread
View Single Post
Old 06-01-2011, 05:53 PM
  #2776  
dmatter
Tech Fanatic
iTrader: (2)
 
dmatter's Avatar
 
Join Date: Nov 2004
Location: Galloway, Ohio
Posts: 861
Trader Rating: 2 (100%+)
Default
Originally Posted by Warren Weaver
if you are running a d3 you do have to grind the rotor shaft i used a diamond cutter for the dremel and it worked awesome just be careful it will take a lot of material off fast.
Wow you are good!

I was just about to ask if it was only a D3 issue! I kind of noticed it was a little skimpy on the flat

Thank you!

Dax
dmatter is offline  
Reply