Originally Posted by
spongerX
Finally got my TC6. Has anyone else had issues with the hinge pins? All 4 of my inner ones are slightly bent. I thought it might have been my setup board but I rolled one of my old TC5 hinge pins and it rolled true. The TC6 hinge pins seem to have a rough edge as well where the older TC5 have a nicely bevelled edge.
Are there any tricks to getting zero rebound on the shocks? I've drilled a small hole in the cap but can't seem to get consistent rebound building them the same way I would my TC5 shocks.
As for the shocks I normally put the bladder in at a 45deg angle and then push out the excess oil. I do this until no extra oil comes out, this along with the hole in the cap makes a really dead shock. Also make sure you use a shock pump and ensure that you get all of the air out of the oil.