Originally posted by Isaac
I have 3 degrees of toe in on each side. That's each wheel on both sides are 3 degrees inward. I measured a TC3 on my Hudy and also has 3 degrees of toe in on each wheel.
I also think 260F is still too hot for the motor. I thought it was 240F.
There are also a few factors too!
1. how are you temping your engine?
2. What kind of temp gun?
3. are you temping the glow plug or heat sink?
if you are temping the heat sink your reading will be higher and if you are temping the glow plug it will be more accurate also the distance between the glow plug and your temp gun.
I am using Reytek infrad temp gun and I push it against the heat sink and shot straight to the glow plug. (the body that I am using allow me to cut a big hole above the engine so I could get the temp gun as close to the head as possible!)