Originally posted by markp27
What's the best way to remove the conrod from the crankshaft - It takes me ages to get the conrod removed as it keeps getting stuck on the last bit of the crankshaft's conrod pin Any tips would be appreciated
!!! Dont do that !
If it still stuck.. good, dont remove it. Mostly a "new" engine is difficult to pull out the engine. Should be easier after completely broken in.
If still hard to do, (if it was my engine) I prefer to let it there.
Just take up the sleeve and spray the piston and crankshaft with CRC(contact cleaner) or Permatex(carb/choke cleaner).
Do not use your kungfu for this part.