i ended up 'massaging' the lower pod removing just over 1.5mm of carbon on the non drive side edge and now i have good clearance.
drove a few practice runs today and i was pleased, wished the car had 1 ovalized servo hole to move side to side. think i'm quite far out on the tierods to point where i want some piece of mind and snap up some slightly longer units (damn i just sold all my b4 stuff).
boy do i need a truer, dont like leanin on others, but its been a while for me and foam.
any1 still 'not' trim rear wheel wells out ala some of those old Lola prototypes from the 80s/early 90s?
R