Hello,
Having problems with my 733 clutch, the retaining nut that tensions the spring is unwinding during racing, the nut finish's up flush with the end of the crank thread and its running against the clutch bell, i have been spacing the bell out with shims as you do so its not dragging on the clutch bell.
Pain in the rear problem.
Any Idea's would be appreciated.
Les
what pre load are you running Les ? i think Rodney had this issue too, and the lack of preload he was using allowed it to unwind. if that is not the issue, you can use blue loctite and let it go off. the new flywheel nuts have a red coating on them, this tends to lock them on when wound up. can always ring me as well when you get stuck.