Originally Posted by
Timbulb
1. How much play do you guys have in your front drive shaft? Mine seems almost too short. It moves a good half inch forward and backward like they installed a driveshaft of the wrong size. The rear one is fine and only moves a fraction of an inch. This is creating a lot of drivetrain noise. Is it possible they installed the wrong size?
on my AE sc10, the manual says to stick some o-rings in there to act like a thing to force the rear drive shaft just enough so it doesnt bottom out but give enough give when it does...
mine moves about .25"..
2. My wheelnuts seem to loosen very easily. Will notching the wheelnuts remedy this?
i just bought a 17mm socket along with a stubby socket wrench so i can crank down on that nut...
try putting just a dab of blue locktite... just a dab.