Originally Posted by
segreda
never tought of it... YES IT S NEW!!!!!!!!!!!!
just put it for practice past saturday ( pracrtice like 1/2 gallon)
just open the cltuch to inspect and yes its very dark ( clutch bell material) will do the clutch maintenace and hit the track this saturday...
sorry to bother again ( how much time aprox will i have to run it until it doesn t slip more???)
will put 2 1.1 to get a stiffer clutch setup and if that doesn t work... will try the nova long header ( saving this change for last)
thanks vry much
appreciated houston
first off this should be discussed in a clutch forum but
did you use a new clutch bell?
did you scuff the clutch bell before installing ?
did you clean the grease out of the bearings ?
did you break in the clutch by giving it copious amounts of throttle then putting a load on it by forcing it to the ground ?
is your flywheel nut tight and not slipping?
go through that checklist then get back to me
hope this helps