Originally Posted by
Matt @ Pro-Line
Yes, that is it but the second run is not in stores yet and will either start shipping today or Monday. The only way to tell is that the bearings now have a black rubber seal instead of just shielded.
Well I decided to try out the first version, and installed last Friday. I did not notice any more slop than the kit has to begin with. I just went with the AE bearings since there was a question about the Proline bearings. I raced on Saturday and didn't have any problems, in fact I think my truck was steering tighter, but that may have been due to some other minor changes I made.
FYI, I could only run the two spacers on the bottom, the hub would bind with 1 and 1 or both on top. Also, I don't know why PL doesn't include instructions. Not that it was real hard, but I did screw up the metal washer placement to begin with.