R/C Tech Forums - View Single Post - Weird Break In Issue Losi 454/8ight-T
Thread: Weird Break In Issue Losi 454/8ight-T
View Single Post
Old 05-15-2011 | 08:34 PM
  #11  
Jake C6R's Avatar
Jake C6R
Tech Addict
iTrader: (8)
 
Joined: Jan 2011
Posts: 557
From: Simi Valley, CA
Default
Originally Posted by 808gx7r
i doubt factory is that far in. try 4 full turns out. make idle gab .7-1mm then lean lsn one hour at a time untill it idles

Thanks for the post. Believe it or not the Losi 454 manual says 2 1/2 turns out on both the HSN and LSN but I think you are right - I did a little searching and found a lot of people that said the specified 2 1/2 turns for each is way too lean!

From the factory the actual settings were HSN 4 1/2 out and LSN 3 1/2 out but that was so rich it would barley run or heat up at all.

I have a few nitro cars but this is my first Losi and I have never seen the supposed "factory" settings so far off.
Jake C6R is offline  
Reply