Originally Posted by
j_blaze14
why not just splice the connector and wire to the thicker wire? i've done that before and it works fine. i think you went a bit too far on this one.
I just didn't think there would be enought room in the bottom of the tray for that much extra wire, and it was thick!
I think I am going to just get rid of the pcb board and give that a shot. The instructions say that it allows the battery to be charged from inside the radio using the nimh charger but I wont ever be doing that. There is a voltage drop of .3 volts on the board itself but I don't think it will hurt anything running it without the drop.