Originally Posted by
BDRMBULLY
i just tossed the 4600 tenshock in my ride with MMP and i got some cogging issues. i set the bec to 6.0 from 5.5 it got a lil better and slowed the deadband a bit but is there any other suggestions to help with the cogging? also this truck is heating up my batterys pretty good and some swelling. 5000 50 c cells . maybe i need better battery's to run this beast. down to a 15t and motors coming in near 164. baterry's at 113 and esc roughly same.
thanks alot
You are WAY too big on the pinion. Drop down to an 11t or 12t. With that big of a pinion you are drawing massive amps, and I doubt your temps are correct, as I come off mid 160's with a 12t and the same motor. Drawing that many amps will also cause a voltage shortage to your rx and cause the glitching and cogging. The MMP has issues even under optimal conditions and will need a glitch buster at least.