Originally Posted by
rc-racer75
I am running savox 1268 servo, MMP SCT system, Spektrum micro receiver, M11 with spektrum module not the pro. i know the savox is a high voltage servo. My problem is that it is glitchy and also effects the motor and esc. How do I eliminate this any help is appreciated. Also, I am running a 35C 5000mah 2S lipo.
The MMP does not a real heavy duty BEC. I was running into some of the same problems with eh Savox TG1258 servo as well.
I purchased capacitorys online and made my own with two caps for the rx to help keep the voltage spikes up. Also if you have a Castle-link, bump the voltage from the default 5.5 to 6.0, More volts pull less amps. Finally make sure you end points are set correclty so the servo is not pushing agains a stop causing a high amp draw as well.
Hope this helps