Originally Posted by
JMD51
Guys,
I posted about this about 2 days ago. Same issue, and yes my cvd pins came out. I had just put electronics I'n and was setting mesh and belt. I shimmed like crazy, but unneccesaily to fnd out. Once u put the hex's and wheels on tight, they are tight as well and o issues. However, I like mine really tight so when I have it on the bench and am working, like I was, they won't come off. So I ended up using 2 each rear 2 front. Still may add 1 n front tho.
Easiest Solution...
Remove Hex and Drive Pin. Use a very small dab of shoe goe on the pin and a little bit in the drive pin side of the hex. Bolt wheel back on and let dry. Now when you pull your wheels off the hexs don't move but you can pop them off easy enough if needed for service.