Originally Posted by
VegasHB
I believe so, the hex adapter is on and there's still a good bit of movement. I'll need to throw a wheel on and see what happens but that just brings up another issue of having to mess with the pin every time I remove the wheels to make sure it's seated properly.
I just need to get some more but it doesn't state what size they are in the manual.
Guys,
I posted about this about 2 days ago. Same issue, and yes my cvd pins came out. I had just put electronics I'n and was setting mesh and belt. I shimmed like crazy, but unneccesaily to fnd out. Once u put the hex's and wheels on tight, they are tight as well and o issues. However, I like mine really tight so when I have it on the bench and am working, like I was, they won't come off. So I ended up using 2 each rear 2 front. Still may add 1 n front tho.