Originally Posted by
VegasHB
I believe so, the hex adapter is on and there's still a good bit of movement. I'll need to throw a wheel on and see what happens but that just brings up another issue of having to mess with the pin every time I remove the wheels to make sure it's seated properly.
I just need to get some more but it doesn't state what size they are in the manual.
You haven't "snapped" the hex all the way onto the pin. The play behind the hex to bearing should be .1-.2mm not very much at all.
If you have installed and tightened the wheels on and then remove you should see that this process will click them into place. Other wise you have to hold the driveshaft into the hub and push the hex on to snap it over the pin.
