R/C Tech Forums - View Single Post - Keep Stripping Screw for Engine/Flywheel related
Thread: Keep Stripping Screw for Engine/Flywheel related
View Single Post
Old 05-13-2011, 07:46 AM
  #7  
Ruune
Tech Fanatic
 
Ruune's Avatar
 
Join Date: Aug 2008
Location: Texas
Posts: 891
Default
+1 on the hardened steel cap head screws. If you use loctite, only use blue/non permanent.

I use cap head screws and hold the flywheel in a cloth with some channel locks, then tighten the piss out of the screw.
Ruune is offline  
Reply