R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 05-12-2011 | 01:32 PM
  #13797  
inferno13
Suspended
iTrader: (202)
 
Joined: Dec 2009
Posts: 7,916
From: northern michigan
Default
Originally Posted by GOREVO25
Hi guys,

I have a GO sport 25 engine that I'm going bump starter box with and I need to apply a back plate on it instead of a pull-start. Does it absolutely need a Go back plate to work? Is there any other compatible back plate crosses out there that will work for this motor??? Can i just make a teflon cover for it??? Can I just apply a pull start casing to seal it up??? I need advice please!!!!

WHAT SHOULD I DO????

Thanks,
M
if the GX series back plate will fit i have one. just need to find out if its the same, im sure someone will chime in with a yes or no
inferno13 is offline  
Reply