R/C Tech Forums - View Single Post - SC10 4x4 Thread
Thread: SC10 4x4 Thread
View Single Post
Old 05-11-2011 | 04:22 PM
  #504  
Cameron Kellogg's Avatar
Cameron Kellogg
Tech Champion
iTrader: (45)
 
Joined: Nov 2007
Posts: 5,776
From: Idaho
Default
Originally Posted by Keeferton
I installed the belt based off the instruction manual suggested pulley position. It seems pretty tight and adding quite a bit of drag break. I am running the MMP w/ castle 3800kv motor and the motor was warm but the esc was hot. Never even had the fan come on before this truck. Is my belt too tight? Will the belt eventually break in and stretch?
There is a section in the back of the instruction book on breaking in the belt and then re-adjusting the tentioners.
Cameron Kellogg is offline  
Reply