So i got mine finished today!

I think there is an error in the manual. I had MASSIVE camber on the front, i had followed everything correctly, double checked, and triple checked with a mate.

The manual says on page 14 to put the ballstuds in the inner holes,
Then page 18 has the measurements of the camber and steering links.

This resulted in having massive camber, im guessing it was a mistake in the manual, it seems if you use the outer holes it will be a lot closer to having the correct camber?.

We ended up using a camber gauge and worked it out.

Secondly: Turnigy 5200 Hard Case Batteries dont fit too well at all, i know alot of people out here run those and will need new batteries for this car, they are too high and needed a screwdriver to remove them. The turnigy soft packs fit, but are a tight fit,even cut some off the rx tray but it didnt help with the wires. The soft packs dont fit with the turnigy label facing down, they just dont pop in, but work with the label facing up, then the wire is on the opposite side.

The reedy 1 cell 5200 packs fitted perfectly, like they were made for it.

Has no one else ran into this? Can anyone confirm if im right?