Any help for a duratrax de10? Brand new, fired up just fine then thought I would play with the settings and now I can't get it back to the factory setup. I follow the instructions but noticed that now the tones that should come from the motor as signals are very, very low in volume. When I first plugged it up, the tones were very audible. I have gone through the drill to restore the factory setting three times and while it appears that I get the proper light flashes, I never have any power going to the motor. Radio gear is a almost new Futaba 3PL and receiver, steering servo works fine and of course the ESC sees the signals from the transmitter as I step it through the reset process.

Thanks for any clues or help you can provide!