Originally Posted by
ZooB
i have a question about the AE setup sheets and rear toe.
i havent seen where they specify which rear suspension mount they use? is it implied that they are using the 2.5* unless otherwise stated? it always says what rear hubs they use, but never which arm mount....
maybe im blind but could someone help me out with this? thanks.
Originally Posted by
mellow
The total toe is calculated by adding the toe block and the hubs, so if you're running .5 degree hub carries and a 2 degree toe block then you have a total of 2.5 for your toe. Hope that makes sense.
Originally Posted by
PFKAOG
Wouldnt it be 3 deg toe total? .5 hub on each side = 1 deg toe plus 2 deg toe on the mount
No it wouldn't be 3 degrees of total toe, you only use .5 degrees once if you have them on both sides. with a 2 degree block and .5 rear hubs, the total is 2.5. You only count the toe on one side for your total degrees of toe in