Originally posted by rc_square24
why does my setup system(hudy type) shows that one side of my rear axles as 2deg(exactly) and the other as 3deg.
the car is new, stock parts so the 2deg side should be 3 instead of 2.
anyway to fix this or its my systems problem? im using the integy made set.
i also found that on both diff cases there were material scratched off where the beveled gear spins closest to, even with one shim on the bearing.
this is what i did
cutting material off the bevel gear makes it weaker. in an event of a crash..your bevel will bend/deform and may cause to rub agains the diff housing...
I highly recommend the PRP diff plate. it solve all problems of any diff problems.
