Originally Posted by
asw7576
Hey there,
How do you end up with 270mm rear track width ?
( I wish I could get 264-265mm rear track width in my mrx4 without exposing too many threads in the lower arms ).
( I wonder if MRX5 lower rear arms are wider than MRX4 ? )
Originally Posted by
bobbyblaze
i was thinking the same...are your rear driveshafts not coming out
its just for fun doing it..the base im using mrx3 kit,the rear conversion only mrx4x,i notice the rear abit wide..so im thinking of getting 262-265 rear,but rear upright from mrx4 is abit wide from mrx3 rear upright...
and for the rear driveshaft im using from mrx4...since mrx3 driveshaft abit short..but since have alot of time to do..will try out the mrx4 conversion to mrx5..
sorry if the picture abit dark and not detail..will upload some picture after finish up everything