R/C Tech Forums - View Single Post - Xray T1
Thread: Xray T1
View Single Post
Old 05-29-2004, 09:13 PM
  #7177  
Rob Mincey
Tech Fanatic
 
Rob Mincey's Avatar
 
Join Date: Jun 2003
Location: Tulsa, OK
Posts: 872
Default

Ran my new T1 FK tonight - have been running an Evo2 FOC since January.

I have a couple of questions, though:

1.) Has anyone else had problems with the rear suspension binding when attempting to move the outer rear links to the outer position on the rear hubs (rather than the inner position as dictated in the "stock" setup?)

I'm considering grinding the inside of the rear hubs where the camber link attatches to the inner hole so that the suspension's uptravel isn't compromised. Anyone else tried this?

2.) Also, I set the FK up with the same setup I was running on my FOC (well, as close as I can, anyway) and the handling is way off in comparison. Has anyone else run into this? And, if so, what did you have to do to get back the the same handling you had with the FOC car?

Any help you can offer would be greatly appreciated.

Rob
Rob Mincey is offline