Originally Posted by
THE DOC
Question of the day??
We were at the track today for a day of practice and I noticed the truck handling funny, after getting back to the table we found that the droop screw on the driver side was tightened up and that the passenger had more droop, now this is not the only time this has happened. what make's the droop screw tighten itself up. We cant figure it out
If you didn't do the droop pad mod (drill, tap, and use 8ight droop pads) then the chassis wears out (and fast) Depending on how it is wearing into the chassis and depending on how loose the droop grub is in the arm I think it would be plausible that it could back itself off some on its own with normal use. Also note if the chassis wears differently on either side the droop can also get a little out of whack.
just a guess..