Yes it looks that way. I guess my engine replacement program, ON FACTORY DEFECTIVE ENGINES was to much for them. I have replaced over 180 defective engines out of my pocket, from pin holes in the cases (bad castings), holes drilled off center in the clinch bolt area(cracks and leaks), wrist-pin clips popping out the exhaust port, crank threads undersized to the point the clutch nuts would slide on and off. With every new batch of engines there was always a new problem. So I decided not to except anymore replacements from the factory and demanded a refund on the bad engines I sent back to the factory, and this is the response,,,, to find another importer....
No worries the engine design is mine along with the write-ups. I am talking with two Italian factories about manufacturing my design, so I'll have another JS Engine line ready soon. I'd love to have it made in the USA, if I could get the cost down