KR 26.4.2011.pdf

Unsure if the above PDF can be accessed - basically need some help with setup - need initial acceleration punch at corner exit - top end from what I can see is almost there (reached just about at the end of straight) but with extra punch should get there earlier and thus can be used properly.

One other thing is that I cannot at the moment increase FDR due to postage issues.

Track was dirty and dusty so wheel spin could have been causing some play but not a likely issue with the exit of 180 hairpins (3 in total) which is where I seem to be struggling with.

FDR 4.56
Novak Ballistic 21.5 with 25 degree mechanical timing
Temps average between 55-65C
Track temp 28C - dirty and dusty
Trims linear - no expo
DDRS 9
Boost timing 42
Turbo slope 24 units/0.1 sec
Turbo Timing 24
Boost start rpm 2000
Turbo delay 0.1sec
Timing ACC 150 rpm/unit

Any ideas would be highly appreceated