Originally Posted by
spammy
can anybody explain to me how to get zero rebound.yes i did drill the cap but explain your tricks to build shocks with zero rebound thanks
This is how meen v builds them
1. Fill the shock with oil and remove any air
2. Push the piston fully into the shock
3. "Bend" the bladder slightly and insert it into the shock allowing the oil to spill, then "press" the centre of the bladder with the tip of your pinky finger - a little more oil should spill and the bladder will be held in place by the air pressure
4. Place the cap on the shock, hold the shock by both ends (i.e. shock cap and shock bottom) so that the cap is pressing down on the bladder, then tighten - there's an art to doing this, it feels like you need 6 fingers at first.