Bill, I should have parts go out to you by Wednesday.

And guys... the pictures that Bill posted don't do the chassis justice. Those pics were back in January of the first prototype that Bill did using my parts car as drawing board. Heck, the stock chassis I sent him was bent, there were some stripped screws, and it was far from a clean car.

We'll be working on finalization of the 811 plate within the next couple weeks to make sure fitment is 100% correct. Even the prototype that Bill sent me was really close for a first try... within 90% of what I'd consider production. With having to design a plate by copying a bent stock one, he did one heck of a job. There's just a couple little fine tuning items that have to be done and then just double check fitment again.

The final production product will be bad a$$.