Originally posted by bleach1
Im building an mtx3 prospec and am having a little problem with the clutch. I am following the steps but even without any shims behind the thrust bearing there is no play and the hub is locking against the clutch shoe. I am using a Jp rossi engine and the kit supplied collet. any ideas?
if you have no shims behind the thrust bearing, (ie closest to the hex screw head) and it is still tightening up to the point that the bell doesn't spin it means that the flywheel collet is not going far enough into the flywheel. use another flywheel collet that is worn down a little and see if the flywheel is pushed in towards the engine more. IS THERE A LARGE GAP BETWEEN THE MOTOR AND FLYWHEEL??
come to mbank sunday, and i can lend you one of my collets, hopefully they fit better.