Originally Posted by
bigmatt
I'm surprised there isn't more chat on the usa thread. Am I the only one who owns it? I know the next 1 I buy I will do ALL the normal prep I always do. But I will not take it apart!!!!!!!!!!!!!! Only to seal.
Don't even take it apart to seal it Matt - there is no need.
I have never sealed any GO motor I have owned, and have never had a problem. The 2 x carb O Rings, pinch bolt O Rings and the back plate O Ring are all you need. I reckon the less you disturb the O Ring seals the better, so unless you are doing a routine check of rod play etc, or changing rod / bearings just leave it alone and run it.