Originally Posted by
2wdrive
I had a simmilar problem yesterday. I run a hobbywing xerun 10.5t in my pro10 with a 120A v2.1 and all of a sudden it stutterd and stalled a little on the straight. I could drive slow but that is it. After a lap or so i could drive normal again. First i thought it could be the temperature protection but my motor was only 50-55 degrees after the race.
Today i opend the motor and found out that the 3 screws that hold the sensor board had all backed out almost completly. I already thought the sensor socket felt a little loose and now i know why. The sensor board was rattling in the motor. I hope it solved my problem.
I have one 60A esc running 119 that goes into slow mode about 3/4 of the race in. Changed motors, sensor leads and batteries. The only thing to stop it was a replacemet HW 60A esc also running the same 119. No problems. So what the devil is it?? It's driving me mad!!!
