Originally Posted by
orijen
Can't figure this out, I have had the whole front end apart, replaced the bones, cups, hinge pins, HP holders ETC. but the bone only goes into the front cup a couple MM even with 110% droop. The chassis is new as well. The arms are not rounded out at any corner either. Next step is to replace the spindle and carriers but would like some insite or a possible thread linked if you know what my problem could be please.
There has been a running change on the bones. The new one are a little over 2mm longer. I bet if you measure them yours are right around 148mm. The new ones are just a tad bit over 150mm. Call Losi, not all of the tech guys know this. This comes from Adam Drake on the Losi forum.