Originally Posted by
Fordplay
The servo is just drawing too much power. When this happens (especially with Spektrum), they loose signal for a second until it rebinds.
Just install a CC BEC or you can try a cap on the receiver.
For servos that draw high amperage you should look into high discharge Lipo rx packs like this one:
http://www3.towerhobbies.com/cgi-bin...4&I=LXSFS7&P=K
Running one of these with a cap inline with eliminate any possibility for feedback glitching. THe problem with too many rx batteries on the market is that they have a very LOW discarge rate potential in the 1-2amp range. The new ones that are able to discarge at 10-12amps and higher are the way to go.