Bony85

HI All

Just interested in understanding what changing the inner camber link height does, at that end of the car;

1. raising/lowering the front inner camber link - keeping all other bits equal
2. raising/lowering the rear camber link - keeping all other bits equal

I plan to fiddle with these settings next time I get a test day, ie change the front from 4-6mm over a couple of runs, and the rear from 3-5mm over a couple of runs and see if i can tie my findings back to what you think they should be (note i realise these changes are extreme, but i'm not good enough to feel the difference of a 0.5mm change but plan to at least have the learning there so i can make a minor change if needed at a big meeting)


Thanks

Mark