Originally Posted by
Sean Earnest
I'm having a problem unstinting this sway bar set up. The locknut that tightens down on the a-arm that holds the pivot ball it place, do I leave the nut loose so the pivot ball moves freely or do I Leave it tight so it doesn't move? The other question is I have no clue how high or low to run the pivot ball coupler that holds the swaybar, it states it in the manual but I'm not very clear on what the he'll I'm doing.
I put o-rings in first and then tightened them down. Holds them tight while being loose enought for the ball to pivot smoothly.