R/C Tech Forums - View Single Post - U.S. Vintage Trans-Am Racing
View Single Post
Old 04-06-2011, 06:29 AM
  #11151  
Kevin K
Tech Champion
iTrader: (32)
 
Kevin K's Avatar
 
Join Date: Aug 2001
Location: In a land of mini-mighty mental giants
Posts: 8,854
Trader Rating: 32 (100%+)
Default

Originally Posted by andrewdoherty
This is what I was doing, except after getting it set by feel, when I wanted to ensure I had it even side to side and get a value to start with in the future, I found my droop gauge was not tall enough by quite a bit to reach the bottom of the arm. I was checking to see if anyone had a simple solution that would allow me to use my gauge.
Sounds like you need smaller blocks under the chassis.....try a couple spur gears....make sure they are the same thickness. Let the chassis rest on them this will lower the chassis and make your gauge useful.
Kevin K is offline