Originally Posted by
Solara
Double check that solder connector on your ESC's receiver wires...that 3 joints are easily broken and you need to resolder them again.
The new style club spec use the PLUG type to elimnate problem like that.
Tested the ESC connector at the receiver - OK
Tested connection from ESC connector to ESC - OK
Tested signal at receiver - OK
Tested signal between receiver and ESC - OK
So, all wires and connections are good. The yellow light that indicates the ESC is receiving and utilizing the signal is still not changing and the motor is still not turning.
Any further advice as to how to diagnose the issue? I don't have another BL motor, so I cannot see if that's the problem, however unlikely. Is there a way to diagnose the signal being sent through the 3 motor wires?
Jim