+1
Normally you end up around 1.25 to 1.5 turns in on the bottom end, with the top not far off flush with the original long lsn.
With the newer GXII lsn it seems both needles are not far off flush. I didn't adjust the bottom end on mine much at all from the factory settings and it rocks.
All my motors are here and being distributed today and tomorrow, so lots of happy GO people this week
Time for another order now
One thing guys - if your looking at putting the new head and button on the GX motors, the head bolts are a little longer (2mm) on the GXII to allow for the thicker head button assembly. Part # is S6-3518. May be prudent to fit these with the new head and button.