Anyone run the Xerun 150a & Xerun 2000kv sensored motor combo in a 8th scale truggy? What temps are you seeing?
I'm dealing with motor temp issues on my Jammin X2 CRT truggy that I converted to brushless. Spur is a 48t. I tried a 15t, then a 17t and down to a 16t pinion. No matter what, at the end of a full battery run (low voltage cut-off kicks in at just about the same time) the esc also flashes over-temp for the motor. I installed an on-board temp monitor that saves the max temp seen and am getting about 150degf.
I've been thinking of switching to a Tekin truggy motor, either a 2000kv or a 2250kv.