Originally Posted by
bertrandsv87
Good luck on your project. The only question I had was : does the motor output shaft slip into a precut steel slot without the need for a grub screw to hold it? If so, motor changes would be very easy! Also where would a Nikko F1 chassis fit into your racing event? Keep in mind I have rubber tires, a ballistic 4.5R in there, and it weighs about 1408g !!! What is the F1 rubber minimum weight? I know it's a Nikko(with bearings), but it is fast , and I just want to have fun!!!!!!!
it uses a grub screw on both ends so its not going anywhere and motor changes are very easy, no adjustment and two screws. the Nikko can run but until i see it i cant tell you what class, with that motor it will be Formula one more than likely, in fact if you are running rubber it will be formula one.